He may have the answer. Adaptec itself warns about that. However, holding the bulb up to the light, I noticed black blotches inside; doesn’t look good; probably needs a new bulb at a minimum, don’t you think? Try downloading a more recent version of Vuescan. With the flexible functionality included with the Polaroid 35 Plus, you can fulfill your 35mm film digitizing tasks all the time.

Uploader: Gam
Date Added: 27 November 2005
File Size: 58.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4653
Price: Free* [*Free Regsitration Required]

This item doesn’t belong on this page.

Polaroid Sprintscan 35 Plus – LaserSoft Imaging

Discussion in ‘Scanners’ started by jojax14 yahoo. Other wise, speintscan you do not want to pre-tweak each image prior to scanning, I usually find it best just to scan the images with no ajdustment and do it later in Photoshop.

If not I can email it to you. Be the first to write a pls. If you say it should illuminate when the unit powers on and the green and yellow lights come on, then something is wrong there for starters. Reply I have this question too I have this question too Me too Me too.

The top of the cabinet is easily removable with just four screws. To remove the cover, pull up-out from the bottom.


ASP reports it as the only item on the external scsi bus. I’m inclined to think the lamp power circuit is inop.

But after about 40 perfectly normal good scans my 53 35 Plus all of a sudden disappeared! Also, older fluorescent light fixtures has a small can-like twist-in starter, but again I’m not sure one this small has one.

Ask a Question Want to reply to this thread or ask your own question?

The Windows was extremely clean with only my ATI Radeon drivers installed so i can normally use my monitors instead of x resolution. This item may be a floor model or store return that has been used.

Raw scans with Polaroid Sprintscan 35 plus | PC Review

An unknown error occurred”. View answer in context. When I power the unit, the green light comes on and stays on. Ross, John, Eric, Robert: Don, Aug 30, The lowest-priced item that has been used or worn previously. Posted on Dec 1, 2: To start the conversation again, simply ask a new question.

On my unit, the carriage that holds the slide, moves lpus over 1 inch during the scan process.


Europeana Collections

In that time i had done like 40 scans and another 80 previewscans. Share This Sprinntscan Tweet. If it’s not showing up then either your scanner died or you have a termination issue. Also, the scanner lamp does not light up at any point, although I don’t know WHEN it is actually supposed to light up in the cycle of a scan.

The cable between the scsi card and the scanner could have gone bad try a different cable but most likely the internal interface of the scanner went out to lunch and forgot to come back. Sort of sophisticated sprintcsan, looks like. Can anyone explain to me how I do raw scans in PolaColor? If vuescan works with your scanner you make basic pre-scan adjustments and apply them to the entire film strip. Polaroid Sprintscan 35 Plus: Set the SCSI address switch on the back of your scanner to a number between 1 and 6 not used by another device.