These servers include a number of sensors that generate entries in the system event log SEL when the sensor crosses a threshold. The product serial number is printed on the server hardware or on the product purchase documentation. The device naming for the Ethernet ports differ according to the OS. Later Sun blade systems were sold under the Sun Blade brand. Note – The screens shown are examples.
|Date Added:||7 September 2005|
|File Size:||10.67 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Sun Fire X4100 Server
The z suffix was also used previously to differentiate the Vz Visualization Server variant of the V server. Note that dun Memory Chipkill option is enabled by default. Views Read Edit View history.
You might try cycling power to the system and entering xyzzy several times. If there are no user accounts that have the ability to reset passwords, you can use the CLI on the SP console to log in to the default user account. Install fre change the user and supervisor passwords.
This requirement is there for security reasons as it prevents access to the default user account from a remote location, that is, you must have physical access to the server to use this account.
Sun Fire X M2 Specs – CNET
You must fully power on the server to complete the reset. Actual version numbers are subject to change over the life of the product.
This requirement enables accountability to be traced to individual users who have access to specific accounts. Sun’s first-generation blade server platform, the Sun Fire B chassis and associated blade servers, was branded under the Sun Fire server brand. The localhost login prompt appears. This supplement contains information specific to the products listed on the title page.
Therefore, all subsequent user account changes creations and modifications and configuration changes should be done using specific user accounts. The default user account password is the product serial number and it cannot be changed. Refer to the section that corresponds to your version of the server:.
Powering On and Configuring BIOS Settings
One of the uses of the default user account is lost password recovery. The SP displays the Password prompt. Sun Microsystems acquired by Oracle Corp If you need to modify other setup parameters, use the arrow and Tab keys to navigate to the desired screen and menu item, then repeat steps To change the system parameters, enter the BIOS Setup utility by pressing the F2 key while the system is performing the power-on self-test POST.
For example, if the server freezes because of incorrect settings and will not boot, use this jumper to invalidate the settings and reboot with defaults.
Caution – Do not operate the server without all fans, component heatsinks, air baffles, and covers installed. This is because the state of this jumper cannot be determined without the host CPU running.
See one of the following: All other fields are nonconfigurable. See Powering Off the Server.
Other ports are mapped by ascending order of PCI bus enumerations. Wait 10 seconds, then remove the shorting jumper. Shut down the server to standby power mode by using a nonconducting pointer or stylus to press and release the recessed Power button on the front panel. One light is positioned on the front of the fure in the upper-left corner, and the other light is on the back of the server in the upper-center section. This procedure describes how to reset the Administration password the root password for the ILOM Service Processor back to the default after it has been set once during initial setup.
Remove the main cover from the server. Set the uboot environment variable, bootretry, to -1 to temporarily disable automatic reboot:.
You can now x400 the default user account to reset the passwords for user accounts for which passwords have been lost. The system monitors six temperature sensors. From Wikipedia, the free encyclopedia.