Once the adapter is firmly in place, secure its fastening tab to your PC’s chassis with a mounting screw. With the connector pin end facing the CardBus slot and the label facing up, slide the Adapter into the CardBus slot until it locks in place. Client Name – The name of the client computer. Highlight a profile in the Auto Selected Profiles box. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. After the files have been successfully copied, the screen in figure will appear. Select which mode the wireless adapter uses to authenticate to an access point:

Uploader: Mikarr
Date Added: 11 January 2012
File Size: 62.27 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 74237
Price: Free* [*Free Regsitration Required]

Download for TL-WNG | TP-Link India

The wireless adapter must match the wireless mode and channel of the clients it associates. The adapter’s auto-sensing capability allows high packet transfer rate of up to 54Mbps for maximum throughput, or dynamic range shifting to lower speeds due to distance or operating limitations in an environment with a lot of electromagnetic interference. However, to an intended receiver i.


The TWCU utility provides a complete and easy to use set of tools to: Specifies the preamble setting in Check tl-wj550g/tl-wn551g your computer manufacturer for instructions if needed.

The following setup steps are for Windows Figure Advanced tab of Profile Management 3. Configure the encryption type on tl-sn550g/tl-wn551g Security tab of Profile Management.

Adapter into the CardBus slot until it locks in place. To an unintended receiver, DSSS appears as low power wideband noise and is rejected ignored by most narrowband receivers.

Wireless PCI adaptor (TP-Link TL-WN551G)

Select the profile name to remove in the Profiles List. Fill in the Profile name and click OK to create the configuration profile for that network. With the connector pin end facing the CardBus slot and the label facing up, slide the. Figure should appear. The Diagnostics tab lists the following receive and transmit diagnostics for frames received or transmitted by the wireless network adapter: Click Export…, the Export Profile window will then appear.

To complete WEP encryption configuration, you must select the The adapter is on wake up status. If the icon is gray, there is no connection.

This manual is related to the following products: Click on the profile name in the Profiles List. Highlight the profile name.


Double-click the icon and the TWCU utility will run. Operation is subject to the following two conditions: Data Encryption – Displays the encryption type the driver is using.

Our drivers have been tested thoroughly, and are able to work with the operating system. The adapter can tl-wn550g/tl-wn551b use short radio headers if the access point supports and uses them.


Click Open, the imported profile will then appear in the Profiles List. Click Run Test to run the troubleshooting utility tests: Locate an available CardBus slot on your laptop. Link Status – Shows whether the station is associated to the wireless network. To install the adapter, follow these steps listed below:. Click OK to reboot the system.

The Profile Management dialog box will display a screen similar to that shown in Figure Status Green Lit The adapter is on wake up status.